Table of Contents
Advertisement
Symptom
The Edge of the Copy is dirty.
The Image on the Copy is not
aligned properly.
Possible Cause
The Original Pad or Document
Feed Belt is dirty.
You have selected a paper size
larger than the original. (Zoom
Ratio is set at full size 100%)
1139O1690A
The original is not placed in the
correct position. (Zoom Ratio is
set at full size 100%.)
The reduction ratio selected is not
in accord with the copy paper
size. (When doing manual
reduction copying.)
The original is not placed in the
correct position.
The originals may not be suitable
for use in the Duplexing
1139O1680A
Document Feeder. (When
Duplexing Document Feeder is
being used.)
The Original Glass is dirty.
(When Duplexing Document
Feeder is being used.)
1. When This Type of Copy is Produced
Action
Wipe the Original Pad or
Document Transport Belt clean
with a soft cloth dampened with
mild detergent.
p. 8-7
Select the same copy paper size
as the original.
p. 3-9
Or, use the Auto Size Mode to
enlarge the copy to the
appropriate size.
p. 3-13
Select the Paper Tray that is
loaded in the same direction as
the original.
p. 3-9
Or, reload the paper in the same
direction as the original.
Select the zoom ratio according to
the copy paper size.
Or, use the Auto Size Mode to
reduce the copy to the appropriate
size.
p. 3-13
Place the original correctly on the
Glass against the Width Scale.
p. 3-3
Or, load it onto the Duplexing
Document Feeder correctly along
the Document Guide Plates.
p. 3-6
Raise the Duplexing Document
Feeder and place the originals on
the Glass one at a time, instead of
using the Duplexing Document
Feeder.
p. 3-3
Wipe the Glass clean with a soft
dry cloth.
p. 8-8
7-3
p. 6-1
p. 3-13
Advertisement
Table of Contents
