Entering An Ekc Password (Ekc) - Konica Minolta 8050 Instruction Manual

Entering an EKC Password (EKC)

The Electronic Key Counter (EKC) allows the Key Operator to monitor all copying
activities by controlling EKC password accounts. Copy quantity limits for specific
accounts can be set.
The EKC is not factory-set. An EKC password is required only when the EKC is
activated, a User Password is assigned, and "Enter E.K.C. password" is displayed
on the touch screen.
Copying will be available by following procedure:
For details of the EKC setting, see p. 14-12 to p. 14-19.
1.
Enter EKC password.
Enter your 8-digit EKC password, using the keypad.
To set an EKC password, see p. 14-14 to p. 14-16.
If an invalid EKC password is entered, continue by entering the correct
password.
2.
Press [START].
Your current copy count and copy limit will be displayed for 3 sec.
Current count / limit
018888/025000
3.
Start a copying job.
When the message changes to "Ready to copy", copying job is available on
the machine.
When your copy count reaches the copy limit, the message "Copy limit
reached" will be displayed. In that case, contact the Key Operator to reset
your copy limit.
4.
Press [ACCESS].
The initial state will be restored, with the message "Enter E.K.C. password"
displayed on the screen.
Turning On the Power Switch (continued)
2-21