Table of Contents
Advertisement
Erasing Outside of the Original (Non-Image Area Erase) (continued)
4.
Select magnification and paper size, as desired.
• APS and AMS are automatically released.
• Copy mode is automatically set to 1 1. If 1 2 is selected, Platen store
mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-10 for details on setting print quantity.
6.
Position original FACE DOWN on the platen glass.
DO NOT CLOSE THE DOCUMENT FEEDER.
Original size should be larger than 10mm x 10mm.
7.
Press [START].
Having Any Problem?
This function may perform incorrectly if the lighting in the work place is directly
over the platen glass. In this case, consult your service representative about
an appropriate place for installation.
10-31
Advertisement
Table of Contents
Troubleshooting
