User Settings - Eaton Powerware Series User Manual

OPERATION
Table 4. User Settings
Description
Set Date and Time
Display Contrast
Change Language
Relay Config
Signal Inputs
Serial Port Config
Parallel Operation Settings
Modem Config
66
EATON BladeUPS

User Settings

The following table displays the options that you can change.
Available Settings
Set Year, Month, Day
Date: mm/dd/yyyy
Set Hours, Minutes
Time is a 24-hour clock.
Adjust contrast with up/down arrow buttons.
Select Language
Available languages depend on model and languages installed.
Relay: [Alarm-1] [X-Slot 1-1/2/3/4] or [X-Slot 2-1/2/3/4]
Setup: [On Battery] [Summary Alarm] [On Bypass] [UPS OK]
[custom] [empty]
Signal: [X-Slot-1] [X-Slot-2] [INPUT 1] [INPUT 2]
[signal inputs]
Logic: [0] [1]
For more information, see "Programmable Signal Inputs" on
page 82.
Port: [X-Slot-1] [X-Slot-2/Serv]
Speed: [19200] [9600] [2400] [1200]
Parallel Operation Mode:
[Redundant Mode] [Capacity Mode]
This setting is not available for six-unit systems (must be Redundant
Mode only).
Parallel XCP: [System] [Sub Unit]
Select Sub Unit for PowerVision software. Select System for
other software.
Auto ID Restart: [Done] [Restart]
Select Restart to reinitialize auto identification (see
"Auto-Identification" on page 87).
Modem Installation: [Not Installed] [X-Slot-1] [X-Slot-2]
Set Modem Call Events
Set Modem Init String
Set Modem Call Command
Set Modem Communication Password
S
®
(12 kVA) User's Guide 164201649 Rev 4www.eaton.com/powerquality
Default Setting
01/01/2003
00:00
Moderate
English
Alarm 1: empty
X-Slots (1 or 2)
#1: UPS OK
#2: On Bypass
#3: Summary Alarm
#4: On Battery
<empty>
[1]
19200
Redundant Mode
System
None
Not Installed
Event #0
Call modem: no
ATZ0
None
None