Eaton Powerware Series User Manual page 38

INSTALLATION
30
EATON BladeUPS
S
Documentation and software tools
- Software Suite CD
- BladeUPS: Documents, Firmware, and Installation Video CD
- This user's guide
S
Mounting brackets and fasteners (if not already installed):
- (2) mounting brackets
- (8) 6-32 flat-head screws
S
Rails and fasteners:
- (2) sliding rail assemblies (left and right)
- (2) rear hold-down brackets
- (16) M5 machine screws
- (8) M5 clip nuts for racks with round holes
- (8) M5 cage nuts for racks with square holes
- (8) M6 hex nuts with integrated washers
Parallel system only. Verify that the following items are included with each Powerware
Hot Sync CAN Bridge Card:
S
CAN Bridge Card cable with (2) RJ-45 connectors
S
Redundant signal cable with (2) two-position terminal block connectors
S
(2) blue terminating plugs
S
®
(12 kVA) User's Guide 164201649 Rev 4www.eaton.com/powerquality