REPO (NO)
REPO (NC)
Load
Connector
Communication Port
Output Power Cord
Figure 32. BladeUPS Module Rear Panel (Standalone UPS Shown with IEC 309-60A Output Power Cord)
Parallel UPS Installation
X-Slot Communication Bay 1
Ground
Bonding
Screw
Input Power Cord
NOTE The load connector breaker controls the load connector only, not the output power cord.
Follow the appropriate procedure for the type of parallel configuration.
S
Follow the procedure "New Multiple Parallel UPS Installation" on page 44 if you
are installing multiple UPSs in a new parallel configuration.
In this case, two blue terminating plugs are supplied with each UPS. None of the
Powerware Hot Sync CAN Bridge Cards contains a Jumper J7.
EATON BladeUPS
®
(12 kVA) User's Guide
Load
Connector
Input
Breaker
Breaker
X-Slot Communication Bay 2
S
164201649 Rev 4www.eaton.com/powerquality
INSTALLATION
Battery
Breaker
UPS
Battery
Connector
Surge
Protection
(leave
installed)
43