Eaton Powerware Series User Manual page 100

UPS MAINTENANCE
92
EATON BladeUPS
3. Remove the eight screws on the battery cover plate and retain. Remove the
plate. See Figure 56.
S
The UPS internal batteries are heavy (see page 99). Each battery tray holds two rows of five batteries.
Use caution when handling the heavy battery trays.
S
Pull the battery trays out onto a flat, stable surface. The battery trays are unsupported when you pull
them out of the UPS.
4. Untuck the plastic handle at the end of a battery tray. Pull the handle firmly to
remove the tray. Use both hands to support the tray as it leaves the UPS cabinet.
Repeat for each battery tray. See "Recycling the Used Battery or UPS" on
page 98 for proper disposal.
5. Slide the new battery trays into the cabinet (see Figure 57). Verify that each tray
is properly aligned before sliding the tray in.
When a tray is fully installed, tuck the plastic handle on the end of the tray into
place.
S
®
(12 kVA) User's Guide 164201649 Rev 4www.eaton.com/powerquality
Figure 56. Removing the UPS Battery Cover Plate
C A U T I O N
Figure 57. Installing the UPS Battery Trays