Epson PhotoPC 3000Z User Manual page 80

Enabling the fixed settings feature
Follow these steps to enable the fixed settings feature.
1. Make sure that Manual is selected as the camera
mode. See "Making camera mode settings" on
page 4-5 for details.
2. Turn the camera's dial switch to the
and press the Shot SETUP button.
3. Press the FixSet button to select On. Then press
the Back button.
Proceed to the next section for details on saving your
fixed settings.
Saving your fixed settings
Follow these steps to save your fixed settings.
1. After you have enabled the fixed settings feature,
turn the dial switch to
Note:
You cannot use the fixed settings feature when taking
pictures using the viewfinder.
2. Press the button at the top-right of the LCD
monitor several times until Fixed Settings is
displayed.
4-16
Making Settings
position
.
3. Take a picture. After the camera processes the
photo, the exposure settings that were used for
that photo are displayed on-screen.
To save the displayed settings, press the Yes
button.
If you do not want to save the displayed settings,
press the No button. Repeat this step until you are
satisfied with the displayed settings.
4. To take a picture using the saved settings, simply
frame a shot and press the shutter button. To exit
the fixed settings feature, click BACK.
Note:
To use the fixed settings after exiting this screen, see
the next section.
To see the current fixed settings, press the Fixset Info
button.
To erase the current fixed settings from the camera's
memory, press the Fixset Cancel button.