Replacing The Batteries - Epson PhotoPC 3000Z User Manual

2. Insert four batteries into the compartment,
positioning the + and - ends as shown below.
Then lower the battery cover.
Note:
Do not use different types of batteries together; this can
cause fire or explosion.
3. Swing the battery cover shut and hold it down
while you slide it back to lock it, as shown below.
1-8
Getting Started
When the battery power is almost out, a low battery
icon appears on the display panel. When the
battery power runs out, this icon blinks and the
camera turns off automatically. Remove and recharge
your batteries, then reinstall the batteries.
Note:
When the battery level is low, the LCD monitor turns off
while the flash is being charged. When the charging is
complete, the LCD monitor turns back on.

Replacing the batteries

Replace your PhotoPC 3000Z batteries when the low
battery icon appears on the camera's display
panel. Be sure to replace all four batteries at the same
time. You can replace them with either of the
following battery types.
Single-use AA (IEC LR6) alkaline batteries
Rechargeable AA Ni-MH batteries