Epson PhotoPC 3000Z User Manual page 45

Follow these steps to record a video clip.
Note:
The image quality setting is disabled when taking video
clips.
You cannot use the panorama feature when recording
video clips.
You can record sound with your video clips only while
you are taking the clip. You cannot make an associated
audio recording for existing video clips.
The flash is disabled when recording video clips.
1. Remove the lens cap, set the dial switch to
press the POWER button to turn on the camera.
VIDEO CLIP appears at the top of the LCD
monitor, a white frame appears around the
previewed image, and the total available amount
of recording time (up to 25 seconds) is displayed
at the upper-left corner of the LCD monitor.
Note:
The amount of recording time available depends
on the amount of space available in your camera's
memory card.
To use the macro or digital zoom features when
recording the video clip, first turn the dial switch
to
select MACRO, or the x1 button to select
DIGITAL ZOOM. Then set the dial switch to
and proceed to the next step.
2. To record audio with your video clip, press the
Sound button to select On.
To take a video clip with no audio, select Off.
Note:
For an explanation on using the buttons on the back of
, and
the camera, see "Using the LCD monitor buttons" on
page 2-5.
3. Frame your subject in the LCD monitor, then
press the shutter button to begin recording the
video clip.
The amount of time remaining for recording is
displayed at the upper-left corner of the LCD
monitor. REC is displayed in red directly below
the remaining seconds to indicate that you are
recording.
4. You can stop recording a clip at any time by
pressing the shutter button again, or you can
continue recording until recording time runs out.
and press the Normal Frame button to
Taking Pictures
2
2-13