Tr2715; Tr2716; Tr2717 - IBM Cognos User Manual

Procedure
To resolve the problem, specify a valid measure allocation regime that does not
include a circular reference.

TR2715

Measure measure_name1 is allocated by the calculated measure measure_name2.
Measure measure_name1 is a component of the calculated measure.
This error occurs because you have inadvertently specified an invalid (circular)
allocation. A calculated measure cannot reference a measure that uses that
calculated measure for allocation.
For example, suppose you use the measure Fixed Costs to calculate the Fixed Cost
Ratio measure, as follows:
Fixed Cost Ratio = (Fixed Costs/Sales) * 100
You cannot then use the measure Fixed Costs to allocate values for the derived
measure Fixed Cost Ratio.
Procedure
To resolve the problem, specify a valid measure allocation regime that does not
include a circular reference.

TR2716

Category category_name is inaccessible in dimension dimension_name. No data
can be reported against it in the PowerCube. A category is accessible if it or a
descendant exists in a key level, or it has an ancestor with allocated measure
values.
This message warns you that the dimension you have created contains one or
more categories that cannot be accessed. This situation can occur for one of the
following reasons:
v There is no Current Period category.
v You have created a special category that is not connected to a source category.
Procedure
To resolve the problem, from the Diagram menu, select a date category and use
the Set Current Period command. Also, ensure that the Automatically set the
current period check box is enabled on the Time tab of the property sheet for the
time dimension.

TR2717

Category category_name has no children in dimension dimension_name in at least
one dimension view or Cube Group. This category cannot have a partition
specified.
The Check Model tool has detected a condition in which a dimension view has
caused one or more categories to become the lowest-level active categories in a
Appendix C. IBM Cognos Transformer Error Messages
303