Tr0536; Tr0538 - IBM Cognos User Manual

You have tried to create a new category below the convergence level of an
alternate drill-down structure, and the new category descends from a category
above the convergence level of an alternate drill-down structure. This is not a valid
action.
Procedure
1. Instead, on the diagram, create a new category at the convergence level by
2. Another solution is to create new categories that descend from categories in or

TR0536

Partitioning can only be specified for categories in a primary drill-down path.
You have tried to specify partition numbers for categories in the alternate
drill-down path of a dimension with an alternate drill-down structure. Partitioning
is only supported in the primary drill-down path.
Procedure
To resolve the problem, determine which categories in the alternate drill-down
path have partition numbers specified, then change their partition numbers to zero
(0).
Tip: If you are unsure which categories in the alternate-drill-down path are
partitioned, an easy way to isolate categories with partition numbers other than 0is
to save the model as an .mdl file. You can then open the .mdl file using any text
editor and search for the string NewPartition, to locate all levels or categories with
partition level numbers other than 0.

TR0538

A partition cannot be specified for root, special, or leaf categories.
You have tried to specify a partition level number for a category for which
partitioning is not permitted.
Procedure
To resolve the problem, ensure that you have only assigned partition level
numbers to regular categories located above the lowest (leaf) level in each
dimension.
Note: If a partition level number is assigned to a category in a level that is
excluded, cloaked, or summarized, that category effectively becomes a leaf
category in the resulting PowerCube. As a result, partition level numbers cannot be
assigned to these category types. However, you can assign a partition level number
to the root category of a subdimension.
dragging the pointer from an ancestor level to the convergence level. Make sure
you do not drag the pointer too far to the right.
below the convergence level.
Appendix C. IBM Cognos Transformer Error Messages
265