Tr0523; Tr0524; Tr0525 - IBM Cognos User Manual

You have tried to create a subdimension in one of the paths of an alternate
drill-down structure. Subdimensions are permitted in dimensions with only one
drill-down path or, in an alternate drill-down structure, at or below the
convergence level.
Procedure
To avoid this problem, ensure that subdimensions are positioned at or below the
convergence level.

TR0523

You cannot move this category because its position is determined by its Order
Value property.
You have tried to move a category manually on a diagram when the OrderBy
value for the category has been set by one of the following methods:
v an OrderBy column was specified for the level in which the category resides
v an OrderBy value was explicitly specified for the category in the Order Value
Procedure
1. Ensure that you only move categories for which no OrderBy value is specified.
2. Alternatively, use one of the following methods to change the order of

TR0524

Rollup can only be disabled for special categories.
The Cognos Transformer Windows interface does not allow you to clear the
Category rollup check box when you are working with regular categories.
However, this error message may appear if you try to disable rollup for a regular
category using an MDL script.
Procedure
To resolve the problem, ensure that the ID numbers used in the MDL script refer to
objects for which the stated action is valid.

TR0525

A category was expected but not found. Either you have referred to a category by
an object name or object identifier that Cognos Transformer is unable to locate, or
you have not referenced the category.
box on the Category property sheet
categories for which an OrderBy column is specified:
v Choose another OrderBy column for the level, and have Cognos Transformer
re-order the categories based on this new OrderBy column.
v Disable the current OrderBy settings by choosing the blank entry at the
bottom of the SortBy Column list on the OrderBy tab of the Level property
sheet.
Tip: You can order the categories manually by moving them on the diagram
and then re-enable the OrderBy settings.
Appendix C. IBM Cognos Transformer Error Messages
263