Pppoetunnel - D-Link DFL-260E Manual

3.28.8. PPPoETunnel

NBNS1
NBNS2
AllowedRoutes
MPPEAllowStateful
ProxyARPAllInterfaces
ProxyARPInterfaces
Comments
3.28.8. PPPoETunnel
Description
A PPPoE interface is a PPP (point-to-point protocol) tunnel over an existing physical Ethernet inter-
face. Its IP address is dynamically assigned.
Properties
Name
EthernetInterface
IP
Network
DNS1
DNS2
Username
Password
ServiceName
Chapter 3. Configuration Reference
IP of the primary Windows Internet Name Service
(WINS) server that is used in Microsoft environ-
ments which uses the NetBIOS Name Servers
(NBNS) to assign IP addresses to NetBIOS names.
(Optional)
IP of the primary Windows Internet Name Service
(WINS) server that is used in Microsoft environ-
ments which uses the NetBIOS Name Servers
(NBNS) to assign IP addresses to NetBIOS names.
(Optional)
Restricts networks for which routes may automatic-
ally be added. (Default: all-nets)
Allow usage of Stateful MPPE (less secure, use only
for compatibility). (Default: No)
Always select all interfaces, including new ones, for
publishing routes via Proxy ARP. (Default: No)
Specifies the interfaces on which the security gate-
way should publish routes via Proxy ARP.
(Optional)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface.
(Identifier)
The physical Ethernet interface that connects to the
PPPoE server network.
The host name to store the assigned IP address in.
The network from which traffic should be routed in-
to the tunnel.
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
Specifies the username to use for this PPPoE tunnel.
The password to use for this PPPoE tunnel.
Specifies the PPPoE server service name used to dis-
tinguish between two or more PPPoE servers at-
tached to the same network. (Optional)
130