D-Link DFL-260E Manual page 179

3.52.10. IPSettings
IP6ValidateSyntax
IP6OPT_PADN
IP6OPT_JUMBO
IP6OPT_RA
IP6OPT_HA
IP6OPT_OTH
IP6_RH0
IP6_RH2
IP6_RHOther
LogCheckSumErrors
LogNonIPv4IPv6
LogReceivedTTL0
Log0000Src
Block0Net
Block127Net
BlockMulticastSrc
TTLMin
TTLOnLow
TTLMinMulticast
TTLOnLowMulticast
DefaultTTL
LayerSizeConsistency
SecuRemoteUDPEncapCompat
Chapter 3. Configuration Reference
DropLog)
Validate ipv6 syntax violation. (Default: ValidateLo-
gBad)
Validate when ipv6 padn option data fields are non-
zero. (Default: StripLog)
Validate jumbogram packets. (Default: ValidateLog)
Validate Router Alert packets. (Default: Ignore)
Validate Home Address option packets. (Default: Ig-
nore)
Validate unknown
RFC2460NoSupportLog)
Validate routing header type 0 option. (Default:
RFC5095NoSupportLog)
Validate routing header type 2 option. (Default:
RFC2460NoSupportLog)
Validate routing header other than type 0 or 2 op-
tion. (Default: RFC2460NoSupportLog)
Log IP packets with bad checksums. (Default: Yes)
Log occurrences of non-IPv4/IPv6 packets. (Default:
Yes)
Log received packets with TTL=0; this should never
happen! (Default: Yes)
Log invalid 0.0.0.0 source address. (Default: Drop)
Block 0.* source addresses. (Default: DropLog)
Block 127.* source addresses. (Default: DropLog)
Block multicast
(224.0.0.0--255.255.255.255). (Default: DropLog)
The minimum IP Time-To-Live value accepted on
receipt. (Default: 3)
What action to take on too low unicast TTL values.
(Default: DropLog)
The minimum IP multicast Time-To-Live value ac-
cepted on receipt. (Default: 3)
What action to take on too low multicast TTL val-
ues. (Default: DropLog)
The default IP Time-To-Live of packets originated
by the security gateway (32-255). (Default: 255)
TCP/UDP/ICMP/etc layer data and header sizes
matching lower layer size information. (Default:
ValidateLogBad)
Allow IP data to contain eight bytes more than the
179
option types. (Default:
source addresses