Natpool - D-Link DFL-260E Manual

3.38. NATPool

3.38. NATPool
Description
A NAT Pool is used for NATing multiple concurrent connections to using different source IP ad-
dresses.
Properties
Name
Type
IPSource
IPPool
IPPoolIPs
IPRange
StateKeepAlive
MaxStates
ProxyARPAllInterfaces
ProxyARPInterfaces
Comments
Chapter 3. Configuration Reference
Specifies a symbolic name for the NAT Pool.
(Identifier)
Specifies how NAT'ed connections are assigned a
NAT IP address. (Default: stateful)
Specify which IP Address source to use. (Default:
IPRange)
Specifies the IP Pool used for retrieving IP addresses
for NAT translation.
The number of IP addresses to get from the IP Pool.
Specifies the range of IP addresses used for NAT
translation.
The number of seconds that stateful NAT state will
be kept in absence of new connections. (Default:
120)
Maximum number of statefully tracked NATPool
states. (Default: 16384)
Always select all interfaces, including new ones, for
publishing routes needed for receiving traffic on
NATPool addresses. (Default: No)
Specifies the interface/interfaces on which the secur-
ity gateway should publish routes needed for the re-
lay via Proxy ARP. (Optional)
Text describing the current object. (Optional)
147