D-Link DFL-260E Manual page 128

3.28.6. L2TPClient
TunnelProtocol
OriginatorIPType
OriginatorIP
DNS1
DNS2
Username
Password
PPPAuthNoAuth
PPPAuthPAP
PPPAuthCHAP
PPPAuthMSCHAP
PPPAuthMSCHAPv2
MPPENone
MPPERC440
MPPERC456
MPPERC4128
DialOnDemand
ActivitySensing
IdleTimeout
Metric
MTU
Chapter 3. Configuration Reference
Specifies if PPTP or L2TP should be used for this
tunnel. (Default: PPTP)
Specifies what IP address to use as source IP in e.g.
NAT. (Default: LocalInterface)
Manually specified originator IP address to use as
source IP in e.g. NAT.
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
Specifies the username to use for this PPTP/L2TP
interface.
The password to use for this PPTP/L2TP interface.
Allow no authentication for this tunnel. (Default:
No)
Use PAP authentication protocol for this tunnel.
User name and password are sent in plaintext.
(Default: Yes)
Use CHAP authentication protocol for this tunnel.
(Default: Yes)
Use MS-CHAP authentication protocol for this tun-
nel. (Default: Yes)
Use MS-CHAP v2 authentication protocol for this
tunnel. (Default: Yes)
Allow authentication without Microsoft Point-
to-Point Encryption (MPPE). (Default: Yes)
Use an RC4 40 bit MPPE session key with MS-
CHAP or MS-CHAP v2 authentication protocol.
(Default: Yes)
Use an RC4 56 bit MPPE session key with MS-
CHAP or MS-CHAP v2 authentication protocol.
(Default: Yes)
Use an RC4 128 bit MPPE session key with MS-
CHAP or MS-CHAP v2 authentication protocol.
(Default: Yes)
Enable Dial-on-demand which means that the
L2TP/PPTP tunnel will not be setup until traffic is
sent on the interface. (Default: No)
Specifies if the dial-on-demand should trigger on in-
bound or outbound traffic or both. (Default: BiDirec-
tional)
Idle timeout in seconds for dial-on-demand.
(Default: 3600)
Specifies the metric for the auto-created route.
(Default: 90)
Specifies the size (in bytes) of the largest packet that
128