Gretunnel - D-Link DFL-260E Manual

3.28.3. GRETunnel

Metric
DHCPEnabled
DHCPHostName
EthernetDevice
AutoSwitchRoute
AutoInterfaceNetworkRoute
AutoDefaultGatewayRoute
DHCPDNS1
DHCPDNS2
ReceiveMulticastTraffic
VLanQoSInherit
EnableRouterAdvertisement
Comments
3.28.3. GRETunnel
Description
A GRE interface is a Generic Routing Encapsulation (no encryption, no authentication, only encap-
sulation) tunnel over an existing IP network.
Properties
Name
IP
Network
RemoteEndpoint
EncapsulationChecksum
OriginatorIPType
Chapter 3. Configuration Reference
IPv6 is enabled. (Default: 1500)
Specifies the metric for the auto-created route.
(Default: 100)
Enable DHCP client on this interface. (Default: No)
Optional DHCP Host Name. Leave blank to use de-
fault name. (Optional)
Hardware settings for the Ethernet interface.
Enable transparent mode, which means that a switch
route is added automatically for this interface.
(Default: No)
Automatically add a route for this interface using the
given network. (Default: Yes)
Automatically add a default route for this interface
using the given default gateway. (Default: Yes)
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
Sets the multicast receive mode of the interface.
(Default: Auto)
Set whether VLANs using the interface should in-
herit the IP QoS bits. (Default: No)
Enable Router Advertisement for this interface.
(Default: No)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface.
(Identifier)
Specifies the IP address of the GRE interface.
Specifies the network address of the GRE interface.
Specifies the IP address of the remote endpoint.
Add an extra level of checksum above the one
provided by the IPv4 layer. (Default: No)
Specifies what IP address to use as source IP in e.g.
124