Pppoetunnel - D-Link NetDefend DFL-210 Cli Reference Manual

3.30.9. PPPoETunnel

IP
Network
Broadcast
Metric
AutoInterfaceNetworkRoute
MemberOfRoutingTable
RoutingTable
Comments
3.30.9. PPPoETunnel
Description
A PPPoE interface is a PPP (point-to-point protocol) tunnel over an existing physical Ethernet inter-
face. Its IP address is dynamically assigned.
Properties
Name
EthernetInterface
IP
Network
DNS1
DNS2
Username
Password
ServiceName
PPPAuthNoAuth
PPPAuthPAP
PPPAuthCHAP
Interface address.
The network of the interface.
The broadcast address of the connected network. (Optional)
Specifies the metric for the auto-created route. (Default: 100)
Automatically add a route for this virtual LAN interface using
the given network. (Default: Yes)
All or Specific. (Default: All)
Specifies the PBR table to insert the interface IP route into. It
also means that the specified routing table will be used for all
routing lookups, unless overridden by a PBR rule. (Default:
main)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
The physical Ethernet interface that connects to the PPPoE
server network.
The host name to store the assigned IP address in.
The network from which traffic should be routed into the tun-
nel.
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
Specifies the username to use for this PPPoE tunnel.
The password to use for this PPPoE tunnel.
Specifies the PPPoE server service name used to distinguish
between two or more PPPoE servers attached to the same net-
work. (Optional)
Allow no authentication for this tunnel. (Default: No)
Use PAP authentication protocol for this tunnel. User name
and password are sent in plaintext. (Default: Yes)
Use CHAP authentication protocol for this tunnel. (Default:
Yes)
142
Chapter 3. Configuration Reference