Pipes - D-Link DFL-260E Manual

2.2.40. pipes

-ipdest=<IP4 Address>
-ipsrc=<IP4 Address>
-ipversion=<1...15>
-out
-out-nocap
-port=<0...65535>
-promisc
-proto=<0...255>
-show
-size=<value>
-snaplen=<value>
-srcport=<0...65535>
-start
-status
-stop
-tcp
-udp
-wipe
-write
<interface(s)>
2.2.40. pipes
Show pipes information.
Description
Show list of configured pipes / pipe details / pipe users.
Note: The "pipes" command is not executed right away; it is queued until the end of the second,
when pipe values are calculated.
Usage
Note
Requires Administrator privilege.
Destination IP address filter.
Source IP address filter.
IP version filter.
Realtime packet brief dumped to console.
Unbuffered (not stored in memory) realtime packet
brief dumped to console.
TCP/UDP port filter.
Set iface in promiscuous mode.
IP protocol filter.
Show a captured packets brief.
Size (kb) of buffer to store captured packets in
memory (default 512kb).
Maximum length of each packet to capture.
Source TCP/UDP port filter.
Start capture.
Show capture status.
Stop capture.
TCP filter.
UDP filter.
Remove all captured packets from memory.
Write the captured packets to disk.
Name of interface(s).
53
Chapter 2. Command Reference