Pppoetunnel - D-Link NetDefend DFL-210 Cli Reference Manual

3.28.8. PPPoETunnel

IP
TunnelProtocol
Interface
ServerIP
UseUserAuth
MPPENone
MPPERC440
MPPERC456
MPPERC4128
IPPool
DNS1
DNS2
NBNS1
NBNS2
AllowedRoutes
MPPEAllowStateful
ProxyARPAllInterfaces
ProxyARPInterfaces
Comments
3.28.8. PPPoETunnel
Description
A PPPoE interface is a PPP (point-to-point protocol) tunnel over an existing physical Ethernet inter-
face. Its IP address is dynamically assigned.
The IP address of the PPTP/L2TP server interface.
Specifies if PPTP or L2TP should be used for this tunnel.
(Default: PPTP)
The interface that the PPTP/L2TP Server should be listening on.
Specifies the IP that the PPTP/L2TP server should listen on, this
can be an IP of a interface, or for example an ARP published IP.
Enable the use of user authentication rules on this server.
(Default: Yes)
Allow no authentication for this tunnel. (Default: Yes)
Use an RC4 40 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 56 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 128 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
A range, group or network that the PPTP/L2TP server will use as
IP address pool to give out IP addresses to the clients from.
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
IP of the primary Windows Internet Name Service (WINS) serv-
er that is used in Microsoft environments which uses the Net-
BIOS Name Servers (NBNS) to assign IP addresses to NetBIOS
names. (Optional)
IP of the primary Windows Internet Name Service (WINS) serv-
er that is used in Microsoft environments which uses the Net-
BIOS Name Servers (NBNS) to assign IP addresses to NetBIOS
names. (Optional)
Restricts networks for which routes may automatically be added.
(Default: all-nets)
Allow usage of Stateful MPPE (less secure, use only for compat-
ibility). (Default: No)
Always select all interfaces, including new ones, for publishing
routes via Proxy ARP. (Default: No)
Specifies the interfaces on which the security gateway should
publish routes via Proxy ARP. (Optional)
Text describing the current object. (Optional)
126
Chapter 3. Configuration Reference