Selftest; Interface Ping Test Between All Interfaces; Interface Ping Test Between Interfaces 'If1' And 'If2 - D-Link DFL-260E Manual

2.2.46. selftest

rules -verbose 1-5 7-9
Usage
rules [-type={IP | ROUTING | PIPE | IDP | IGMP}] [-verbose]
[-schedule] [<rules>]...
Options
-schedule
-type={IP | ROUTING | PIPE | IDP | IG-
MP}
-verbose
<rules>
2.2.46. selftest
Run appliance self tests.
Description
The appliance self tests are used to verify the correct function of hardware components.
Normal SGW operations might be disrupted during the test(s).
The outcome of the throughput crypto accelerator tests are dependent on configuration values. If the
number of large buffers (LocalReassSettings->LocalReass_NumLarge) too low, it might lower
throughput result. In the field 'Drop/Fail', the 'Drop' column contains the number of packets that
were dropped before ever reaching the crypto accelerator and the 'Fail' column contains the number
of packets that for some reason failed encryption. The 'Pkt In/Out' field shows the total number of
packets sent to, and returned from the accelerator.
The interface tests 'traffic' and 'throughput' are dependent on the settings for the NIC ring sizes and
possibly also license limitations. The 'traffic' test uses a uniform random distribution of six packet
sizes between 60 and 1518 bytes. The content of each received packet is validated. The 'throughput'
test uses only the largest packet size, and does not validate the contents of the received packets.
Example 2.12. Interface ping test between all interfaces
selftest -ping
Example 2.13. Interface ping test between interfaces 'if1' and 'if2'
Filter out rules that are not currently allowed by se-
lected schedules.
Type of rules to display. (Default: IP)
Verbose: show all parameters of the rules.
Range of rules to display. (default: all rules).
57
Chapter 2. Command Reference