Gretunnel - D-Link NetDefend DFL-210 Cli Reference Manual

3.28.3. GRETunnel

AutoSwitchRoute
AutoInterfaceNetworkRoute
AutoDefaultGatewayRoute
DHCPDNS1
DHCPDNS2
ReceiveMulticastTraffic
VLanQoSInherit
Comments
3.28.3. GRETunnel
Description
A GRE interface is a Generic Routing Encapsulation (no encryption, no authentication, only encap-
sulation) tunnel over an existing IP network.
Properties
Name
IP
Network
RemoteEndpoint
EncapsulationChecksum
OriginatorIPType
OriginatorIP
Metric
AutoInterfaceNetworkRoute
UseSessionKey
SessionKey
Comments
Enable transparent mode, which means that a switch route is
added automatically for this interface. (Default: No)
Automatically add a route for this interface using the given
network. (Default: Yes)
Automatically add a default route for this interface using the
given default gateway. (Default: Yes)
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
Sets the multicast receive mode of the interface. (Default:
Auto)
Set whether VLANs using the interface should inherit the IP
QoS bits. (Default: No)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
Specifies the IP address of the GRE interface.
Specifies the network address of the GRE interface.
Specifies the IP address of the remote endpoint.
Add an extra level of checksum above the one provided by
the IPv4 layer. (Default: No)
Specifies what IP address to use as source IP in e.g. NAT.
(Default: LocalInterface)
Manually specified originator IP address to use as source IP
in e.g. NAT.
Specifies the metric for the auto-created route. (Default: 90)
Automatically add a route for this interface using the given
remote network. (Default: Yes)
Specify whether or not to use a session key. (Default: No)
Session key. (Default: 0)
Text describing the current object. (Optional)
121
Chapter 3. Configuration Reference