Gretunnel - D-Link NetDefend DFL-210 Cli Reference Manual

3.30.3. GRETunnel

AutoInterfaceNetworkRoute
AutoDefaultGatewayRoute
DHCPDNS1
DHCPDNS2
ReceiveMulticastTraffic
DHCPPreferedIP
DHCPAllowStaticRoutes
DHCPPreferedLeaseTime
DHCPLeaseFilter
DHCPServerFilter
DHCPDisallowIPConflicts
DHCPDisallowNetConflicts
VLanQoSInherit
MemberOfRoutingTable
RoutingTable
Comments
3.30.3. GRETunnel
Description
A GRE interface is a Generic Routing Encapsulation (no encryption, no authentication, only encap-
sulation) tunnel over an existing IP network.
Properties
Name
IP
added automatically for this interface. (Default: No)
Automatically add a route for this interface using the given
network. (Default: Yes)
Automatically add a default route for this interface using the
given default gateway. (Default: Yes)
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
Sets the multicast receive mode of the interface. (Default:
Auto)
Set a preferred IP address which will be included in the re-
quest to the DHCP server. (Optional)
Allow the use of static routes send from the DHCP server.
(Default: No)
Set a preferred lease time which will be included in the re-
quest to the DHCP server. (Optional)
Allowed IP address range(s) for the DHCP lease. (Optional)
IP address range(s) for the DHCP servers from which leases
are accepted. (Optional)
Do not allow IP collisions with static routes. (Default: Yes)
Do not allow network collisions with static routes. (Default:
Yes)
Set whether VLANs using the interface should inherit the IP
QoS bits. (Default: No)
All or Specific. (Default: All)
Specifies the PBR table to insert the interface IP route into. It
also means that the specified routing table will be used for all
routing lookups, unless overridden by a PBR rule. (Default:
main)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
Specifies the IP address of the GRE interface.
135
Chapter 3. Configuration Reference