Verifying And Monitoring Atm Pvc Bundles - Cisco 10000 Series Configuration Manual

ATM PVC Selection
Command
Step 1
Router(config)# interface atm
slot/module/port.subinterface
Step 2
Router(config-subif)# bundle bundle-name
Step 3
Router(config-atm-vcb)# pvc-bundle
pvc_name [vpi/]{vci}
Step 4
Router(config-atm-vcb-vc)# no bump
traffic

Verifying and Monitoring ATM PVC Bundles

To verify and monitor QoS for ATM PVC bundles, enter any of the following commands in privileged
EXEC configuration mode:
Command
Router# debug atm bundle adjacency events
Router# debug atm bundle errors
Router# debug atm bundle events
Router# show atm bundle bundle-name
Router# show atm bundle bundle-name statistics
[detail]
Router# show atm map
Cisco 10000 Series Router Quality of Service Configuration Guide
19-28
Chapter 19
Purpose
Creates or modifies a subinterface. Enters subinterface
configuration mode.
Creates or modifies the PVC bundle. Enters ATM bundle
configuration mode.
bundle-name is the name of the bundle to which you want to
attach the VC class.
Adds the specified PVC to the bundle if it does not exist already.
Enters ATM bundle member configuration mode.
pvc-name is a name that you can use to refer to the PVC.
(Optional) vpi/ is the virtual path identifier (VPI). The slash is
required.
(Optional) vci is the virtual channel identifier.
Configures the PVC not to accept any bumped traffic that would
otherwise be redirected to it.
Purpose
Displays information about ATM bundle adjacency change
events.
Displays information about bundle errors.
Displays a record of bundle events.
Displays the bundle attributes assigned to each PVC bundle
member and the current working status of the PVC bundle
members.
bundle-name is the name of the bundle whose member
information is displayed. This is the bundle name specified by the
bundle command when the bundle was created.
Displays statistics or detailed statistics about the specified
VC bundle.
bundle-name specifies the name of the bundle whose member
information is displayed. This is the bundle name specified by the
bundle command when the bundle was created.
(Optional) detail displays detailed statistics.
Displays a list of all configured ATM static maps to remote hosts
on an ATM network and on ATM bundle maps.
Configuring Quality of Service for PVC Bundles
OL-7433-09