Attaching Simultaneous Policies To Pppoe Sessions Traversing An Atm Vc; Attaching A Policy To Pppoe Sessions - Cisco 10000 Series Configuration Manual

Chapter 14 Simultaneous Policy Maps

Attaching Simultaneous Policies to PPPoE Sessions Traversing an ATM VC

To attach simultaneous policies to PPPoE sessions traversing an ATM VC, perform the following
configuration tasks:
•
•

Attaching a Policy to PPPoE Sessions

To attach a policy map to PPPoE sessions, enter the following commands beginning in global
configuration mode:
Command
Step 1
Router(config)# interface type number
[point-to-point | multipoint]
Step 2
Router(config-subif)# range pvc
start-vpi/end-vpi start-vci/end-vci
Step 3
Router(config-subif-atm-vc)# encapsulation
aal5snap
Step 4
Router(config-subif-atm-vc)# protocol
pppoe
Step 5
Router(config-subif-atm-vc)# exit
Step 6
Router(config-subif)# exit
OL-7433-09
encapsulation aal5mux ppp Virtual-Template1
service-policy output pppoa_output_policy
Attaching a Policy to a PPPoA Session, page 14-8
Attaching a Policy to an ATM VC with PPPoA Sessions, page 14-9
Purpose
Creates or modifies a subinterface. Enters subinterface
configuration mode.
type is the interface type (for example, GigabitEthernet).
number is the slot, module, port, subinterface number of the
interface (for example, 4/0/1.10).
point-to-point indicates that the subinterface connects directly
to one endpoint.
multipoint indicates that the subinterface connects to multiple
endpoints.
Defines a range of ATM permanent virtual circuits (PVCs).
(Optional) start-vpi/ is the beginning value for a range of virtual
path identifiers (VPIs). In the absence of the "/" and a VPI value,
the VPI value defaults to 0. Valid values are from 0 to 255.
(Optional) end-vpi is the end value for a range of virtual path
identifiers (VPIs). In the absence of an end-VPI value, the
end-VPI value defaults to the start-VPI value. Valid values are
from 0 to 255.
start-vci/ is the beginning value for a range of virtual channel
identifiers (VCIs). Valid values are from 32 to 65535. You must
specify the slash mark (/).
end-vci is the end value for a range of virtual channel identifiers
(VCIs). Valid values are from 32 to 65535.
Configures the ATM adaptation layer (AAL) and encapsulation
type for the PVC range
Specifies the tunneling protocol that a virtual private dialup
network (VPDN) subgroup is to use, in this case PPPoE.
Exits ATM VC configuration mode.
Exits subinterface configuration mode.
Cisco 10000 Series Router Quality of Service Configuration Guide
Configuring Simultaneous Policy Maps
14-11