Attaching A Qos Service Policy To A Frame Relay Dlci - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Chapter 4
Attaching Service Policies
Example 4-8
slow-VCs and attach the map class to serial interface 2/0/0.
Example 4-8
Router(config)# map-class frame-relay slow-VCs
Router(config-map-c)# service-policy bronze
Router(config-map-c)# exit
Router(config)# interface serial 2/0/0
Router(config-if)# frame-relay class slow-VCs
Attaching a QoS Service Policy to a Frame Relay DLCI
To attach a QoS service policy to a Frame Relay DLCI, perform one of the following tasks:
•
•
You cannot attach a QoS policy to the same Frame Relay interface or subinterface by using both the
Note
MQC and a map class. For releases earlier than Cisco IOS Release 12.0(22)S, use the Frame Relay
commands to attach QoS policies (see
Legacy
Attaching a QoS Service Policy Directly to a Frame Relay DLCI
You can attach a QoS service policy to a Frame Relay DLCI that is configured on an interface or
subinterface.
To attach a QoS service policy directly to a Frame Relay DLCI, enter the following commands beginning
in global configuration mode:
Command
Step 1
Router(config)# interface type
slot/subslot/port.subinterface
[point-to-point]
Step 2
Router(config-if)# frame-relay
interface-dlci dlci
OL-7433-09
shows how to configure a policy map named bronze within a Frame Relay map class named
Configuring a QoS Service Policy on a Frame Relay Interface Using a Map Class
Attaching a QoS Service Policy Directly to a Frame Relay DLCI, page 4-17
Attaching a QoS Service Policy to a Frame Relay DLCI Using a Map Class, page 4-19
Commands"). For Cisco IOS Release 12.0(22)S and later releases, use the MQC.
Appendix A, "Configuring Frame Relay QoS Using Frame Relay
Purpose
Specifies the interface or subinterface. Enters interface or
subinterface configuration mode.
Assigns a data link connection identifier (DLCI) to the Frame
Relay interface or subinterface. Enters Frame Relay DLCI
configuration mode.
dlci is a number that identifies the data link connection on the
interface or subinterface.
Cisco 10000 Series Router Quality of Service Configuration Guide
Attaching Frame Relay QoS Service Policies
4-17
Advertisement
Chapters
Table of Contents
