Service-Policy Command Modes; Usage Guidelines For The Service-Policy Command - Cisco 10000 Series Configuration Manual

Attaching ATM QoS Service Policies
Cisco IOS Release
12.2(28)SB
12.2(31)SB2

service-policy Command Modes

You can configure this command in the following configuration modes:
•
•
•
•
•
•

Usage Guidelines for the service-policy Command

The service-policy {input | output} policy-map-name command is used to attach a service policy to an
interface.
The service-policy policy-map-name command is used to create hierarchical service policies in
policy-map class configuration mode. Do not specify input or output when using the service-policy
command in an hierarchical policy.
In Cisco IOS Release 12.2(33)SB and later releases, the router no longer accepts the abbreviated form
(ser) of the service-policy command. Instead, you must spell out the command name service- before the
router accepts the command.
For example, when attaching a policy map the following error message appears when you attempt to use
the abbreviated form of the service-policy command:
Router(config)# interface gigabit1/1/0
Router(config-if)# ser out ?
% Unrecognized command
Router(config-if)# ser ?
% Unrecognized command
When you enter the command as service-, the router accepts the command as shown in the following
example:
Router(config-if)# service- ?
In releases earlier than Cisco IOS Release 12.2(33)SB, the router accepts the abbreviated form of the
service-policy command. For example, the router accepts the following commands:
Router(config)# interface gigabit1/1/0
Router(config-if)# ser out test
Cisco 10000 Series Router Quality of Service Configuration Guide
4-4
Description
This command was integrated in Cisco IOS Release 12.2(28)SB for the
PRE2.
This command was introduced on the PRE3.
Bundle-VC (for ATM VC bundle members)
Interface
Map-class (for Frame Relay VCs)
PVC-in-range (for ATM VCs)
PVC range (for ATM VCs)
VC submode (for a standalone VC)
input Assign policy-map to the input of an interface
output Assign policy-map to the output of an interface
type Configure CPL Service Policy
Chapter 4 Attaching Service Policies
OL-7433-09