Prerequisites For Define Interface Policy-Map Av Pairs Aaa; Restrictions And Limitations For Define Interface Policy-Map Av Pairs Aaa; Configuring Dynamic Qos Policies At The Session Level - Cisco 10000 Series Configuration Manual

Chapter 17 Configuring Dynamic Subscriber Services
Service-policy output: dyn_out
After a policy map is successfully pulled on the VC, any configuration changes you make using the
[no] service-policy input/output <name> command do not affect the policy map used by the VC.
Entering the show policy-map command displays the pulled policy map. Entering the
show running-config command displays the current user configuration on the router.
To remove the dynamic policy that is pulled from the RADIUS server, use the no dbs enable command
or clear the PPPoA or PPPoEoA session associated with the VC.

Prerequisites for Define Interface Policy-Map AV Pairs AAA

•
•

Restrictions and Limitations for Define Interface Policy-Map AV Pairs AAA

You cannot simultaneously configure a service policy on a VC and on a session.

Configuring Dynamic QoS Policies at the Session Level

To configure dynamic QoS policies at the session level, perform the following configuration tasks:
•
•
Prerequisites
•
•
•
•
•
OL-7433-09
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
0 packets, 0 bytes
5 minute rate 0 bps
Class-map: class-default (match-any)
5 packets, 370 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
5 packets, 370 bytes
5 minute rate 0 bps
Authentication, authorization, and accounting (AAA) must be enabled and already set up to use
RADIUS.
When dynamically configuring a service policy on the ATM subinterface, dynamic bandwidth
selection (DBS) must be enabled on the VC using the dbs enable command. For more information
about DBS, see the "Applying Traffic Shaping Parameters Using RADIUS Profiles" section on
page 17-2.
Configuring the Router for Dynamic QoS Policies at the Session Level, page 17-28
Setting Up RADIUS for Dynamic QoS Policies at the Session Level, page 17-29
Authentication, Authorization, and Accounting (AAA) must be enabled and already set up to use
RADIUS.
PPP over Ethernet over ATM (PPPoEoA) or PPP over ATM (PPPoA) session is established.
Change of authorization functionality is enabled (required for the push functionality)
dbs enable command is configured on the VC.
Policy map is configured on the router.
Applying QoS Parameters Dynamically to Sessions
Cisco 10000 Series Router Quality of Service Configuration Guide
17-27