Cisco 10000 Series Configuration Manual page 324

Verifying Traffic Shaping
Queues Owned but Unused by VC (inheritable by sessions)
Example 9-5
no output packets were discarded due to internal buffer exhaustion.
Example 9-5
Router# show controllers atm 6/0/0
ATM6/0/0, Card type is 4oc3atm-1 (0x02D8)
The current state of the controller is up.
Current configurable parameter settings;
Clock source is LINE, Loopback is NONE, Framing is SONET,
Cell payload scrambling is enabled, STS stream scrambling is enabled,
MTU is 4470, PXF queuing is enabled, hold-queue is 27230
Burst tolerance floor 2
Total subscribed rate is 50000, flowbit change 90 / no change 0
Configuration collisions 0
SECTION
LOF =0LOS=0RDOOL=0BIP(B1)=0
LINE
AIS=0RDI=0FEBE=0BIP(B2)=0
PATH
AIS=0RDI=0FEBE=0BIP(B3)=0
LOP=0NEWPTR =0PSE=0NSE=0
LCD=0
Active Defects: None
Active Alarms: None
Alarm reporting enabled for: SF SLOS SLOF B1-TCA LAIS LRDI B2-TCA PAIS PLOP PRDI B3-TCA
RDOOL LCD
PATH TRACE BUFFER: STABLE
Remote hostname:
Remote interface:
Remote IP addr:
Remote Rx(K1/K2): / Tx(K1/K2): /
BER thresholds: SF = 10e-3 SD = 10e-6
TCA thresholds: B1 = 10e-6 B2 = 10e-6 B3 = 10e-6
Per Card Statistics:
0 Input Packets Discarded, queue exhaustion
0 Input Packets Discarded, no host buffers
0 Output Packets Discarded, no channel
0 Output Packets Discarded, MRED
0 Output Packets Discarded, internal buffer exhaustion
0 Output Packets Discarded, Utopia RX errors
0 Output Packets Discarded, EPD
Cisco 10000 Series Router Quality of Service Configuration Guide
9-20
0 2517/31 pak-priority
ClassID ClassName
0 class-default
31 pak-priority
shows sample output from the show controllers atm command. The output indicates that
show controllers atm Command Sample Output
268 0/32 11
QID Length/Max Res
274 0/32 11
268 0/32 11
Chapter 9 Shaping Traffic
4 0
Dequeues Drops
0 0
4 0
OL-7433-09