Bump Command (Frame Relay Vc-Bundle-Member); Bundle Command; Class-Bundle Command; Class-Vc Command - Cisco 10000 Series Configuration Manual

Chapter 1 Quality of Service Overview

bump Command (Frame Relay VC-bundle-member)

Cisco IOS Release: Release 12.0(26)S
Description: The bump command was introduced on the PRE1 to configure the bumping rules for a
Frame Relay permanent virtual circuit (PVC) bundle member.

bundle Command

Cisco IOS Release: Release 12.0(26)S
Description: The bundle command was introduced on the PRE1 to create an ATM bundle or modify an
existing ATM bundle.

class-bundle Command

Cisco IOS Release: Release 12.0(26)S
Description: The class-bundle command was introduced on the PRE1 to configure an ATM virtual
circuit (VC) bundle with the bundle-level commands contained in the specified VC class.

class-vc Command

Cisco IOS Release: Release 12.0(26)S
Description: The class-vc command was introduced on the PRE1 to assign a virtual circuit (VC) class
to an ATM permanent virtual circuit (PVC) or PVC bundle member.

dscp Command (Frame Relay VC-bundle-member)

Cisco IOS Release: Release 12.0(26)S
Description: The dscp command was introduced on the PRE1 to configure the differentiated services
code point (DSCP) levels for a Frame Relay permanent virtual circuit (PVC) bundle member.

exp Command

Cisco IOS Release: Release 12.0(26)S
Description: The exp command was introduced on the PRE1 to configure Multiprotocol Label
Switching (MPLS) experimental (EXP) levels for a Frame Relay permanent virtual circuit (PVC) bundle
member.

frame-relay vc-bundle Command

Cisco IOS Release: Release 12.0(26)S
Description: The frame-relay vc-bundle command was introduced on the PRE1 to create a Frame
Relay permanent virtual circuit (PVC) bundle if it does not already exist, and to enter Frame Relay
VC-bundle configuration mode.
OL-7433-09
Cisco 10000 Series Router Quality of Service Configuration Guide
QoS Features, Commands, and Changes
1-51