Controlling Packet Queue Congestion; Queue-Limit Command - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Chapter 1
Quality of Service Overview
Controlling Packet Queue Congestion
Documentation Reference:
•
•
•
•
•
•
•
Description: The queue-limit command was introduced on the PRE1 to allow you to specify or modify
the maximum number of packets that a particular class queue can hold.
Description: This command was enhanced on the PRE1 to allow you to simultaneously configure both
the queue-limit and random-detect commands in the same class of a policy map.
Description: This command was introduced on the PRE2 without the ability to simultaneously
configure the random-detect command and the queue-limit command for the same class queue.
Description: This command was enhanced on the PRE2 to allow you to simultaneously configure both
the queue-limit and random-detect commands in the same class of a policy map.
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.
Description: This command was introduced on the PRE3.
OL-7433-09
Chapter 11, "Managing Packet Queue Congestion"
queue-limit Command, page 1-21
random-detect Command, page 1-22
random-detect basis Command, page 1-23
show pxf cpu queue interface summary, page 1-23
Tail Drop Feature, page 1-23
Random Early Detection Feature, page 1-24
Weighted Random Early Detection Feature, page 1-24
Cisco 10000 Series Router Quality of Service Configuration Guide
QoS Features, Commands, and Changes
1-21
Advertisement
Chapters
Table of Contents
