Attaching A Bba Group To An Interface Or Subinterface For Pppoe Sessions - Cisco 10000 Series Configuration Manual

Quality of service configuration guide
Hide thumbs Also See for 10000 Series:
Table of Contents

Advertisement

Attaching Virtual Access Interface QoS Service Policies

Attaching a BBA Group to an Interface or Subinterface for PPPoE Sessions

You can attach a BBA group to physical interfaces and subinterfaces with varying encapsulations, or to
permanent virtual circuits (PVCs).
To attach a BBA group to an interface or subinterface, enter the following commands beginning in global
configuration mode:
Command
Step 1
Router(config)# interface type
slot/subslot/port.subinterface
Step 2
Router(config-subif)# protocol pppoe group
group-name
Configuration Examples for Attaching a BBA Group to an Interface or Subinterface
Example 4-17
sessions.
Example 4-17 Attaching a BBA Group to an Interface
Router(config)# interface atm 1/0/0
Router(config-if)# protocol pppoe group bba1
Router(config-if)# encapsulation ppp
Router(config-if)# pppoe enable
Example 4-18
PPPoE sessions. The example also assigns VLAN 4 to the subinterface.
Example 4-18 Attaching a BBA Group to a VLAN Subinterface
Router(config)# interface atm 4/0/0.10
Router(config-subif)# protocol pppoe group bba-voice
Router(config-subif)# encapsulation dot1q 4
Router(config-subif)# pppoe enable
Cisco 10000 Series Router Quality of Service Configuration Guide
4-28
shows how to attach a BBA group named bba1 to the ATM interface 1/0/0 for PPPoE
shows how to attach a BBA group named bba-voice to ATM subinterface 4/0/0.10 for
Purpose
Specifies the interface or subinterface to which you want to
attach the BBA group. Enters subinterface configuration
mode.
Attaches the BBA group to the specified interface or
subinterface. Enables PPP over Ethernet (PPPoE) sessions to
be established on the interface, subinterface, or permanent
virtual circuits (PVCs).
The router applies the QoS policy of the virtual
Note
template associated with the BBA group. The QoS
policy applies to this interface or subinterface and to
any PVCs configured on the interface or subinterface
without a specified policy.
Chapter 4
Attaching Service Policies
OL-7433-09

Advertisement

Table of Contents
loading

Table of Contents