Wps Station Screen; Scheduling Screen - ZyXEL Communications NBG-4600N User Manual

Chapter 7 Wireless LAN

7.9 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this
screen, click Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Figure 83 Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Table 39 Network > Wireless LAN > WPS Station
LABEL
Push Button
Or input
station's PIN
number

7.10 Scheduling Screen

Use this screen to set the times your wireless LAN is turned on and off. Wireless
LAN scheduling is disabled by default. The wireless LAN can be scheduled to turn
116
DESCRIPTION
Use this button when you use the Push Button Configuration method to
configure wireless stations's wireless settings. See
page 68.
Click this to start WPS-aware wireless station scanning and the wireless
security information synchronization.
Use this button when you use the PIN Configuration method to
configure wireless station's wireless settings. See
page 69.
Type the same PIN number generated in the wireless station's utility.
Then click Start to associate to each other and perform the wireless
security information synchronization.
Section 5.2.1.1 on
Section 5.2.1.2 on
NBG-460N User's Guide