Table of Contents
Advertisement
7.11.2 Security Mode: WPA2-PSK
Use this screen to configure the WPA2-PSK security for your NBG-460N when it
is in AP+Bridge or Bridge Only mode.
Figure 87 Network > Wireless LAN > WDS (WPA2-PSK)
The following table describes the labels in this screen. Refer to
118
for descriptions of other fields in this screen.
Table 43 Network > Wireless LAN > WDS (WPA2-PSK)
LABEL
Pre-Shared Key
7.12 Technical Reference
The following section contains additional technical information about the NBG-
460N features described in this chapter.
7.12.1 Roaming
A wireless station is a device with an IEEE 802.11a/b/g/n compliant wireless
interface. An access point (AP) acts as a bridge between the wireless and wired
networks. An AP creates its own wireless coverage area. A wireless station can
associate with a particular access point only if it is within the access point's
coverage area.
In a network environment with multiple access points, wireless stations are able
to switch from one access point to another as they move between the coverage
areas. This is known as roaming. As the wireless station moves from place to
place, it is responsible for choosing the most appropriate access point depending
on the signal strength, network utilization or other factors.
NBG-460N User's Guide
DESCRIPTION
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters
(including spaces and symbols).
Chapter 7 Wireless LAN
Table 41 on page
121
Advertisement
Table of Contents
Troubleshooting
