ZyXEL Communications NBG-4600N User Manual page 110

Chapter 7 Wireless LAN
To change your NBG-460N's MAC filter settings, click Network > Wireless LAN
> MAC Filter. The screen appears as shown.
Figure 78 Network > Wireless LAN > MAC Filter
The following table describes the labels in this menu.
Table 34 Network > Wireless LAN > MAC Filter
LABEL
Active
Filter Action
Set
MAC
Address
Apply
Reset
110
DESCRIPTION
Select Yes from the drop down list box to enable MAC address filtering.
Define the filter action for the list of MAC addresses in the MAC Address
table.
Select Deny to block access to the NBG-460N, MAC addresses not listed will
be allowed to access the NBG-460N
Select Allow to permit access to the NBG-460N, MAC addresses not listed
will be denied access to the NBG-460N.
This is the index number of the MAC address.
Enter the MAC addresses of the wireless station that are allowed or denied
access to the NBG-460N in these address fields. Enter the MAC addresses in
a valid MAC address format, that is, six hexadecimal character pairs, for
example, 12:34:56:78:9a:bc.
Click Apply to save your changes back to the NBG-460N.
Click Reset to reload the previous configuration for this screen.
NBG-460N User's Guide