What You Can Do; General Nat Screen - ZyXEL Communications NBG-4600N User Manual

Chapter 11 Network Address Translation (NAT)
Note: You must create a firewall rule in addition to setting up NAT, to allow traffic from
the WAN to be forwarded through the NBG-460N.

11.2 What You Can Do

• Use the General screen
set a default server.
• Use the Application screen
service requests to the server(s) on your local network.
• Use the Advanced screen
460N's trigger port settings.

11.3 General NAT Screen

Use this screen to enable NAT and set a default server. Click Network > NAT to
open the General screen.
Figure 114 Network > NAT > General
The following table describes the labels in this screen.
Table 58 Network > NAT > General
LABEL
Enable Network
Address
Translation
Default Server Setup
164
(Section 11.3 on page
(Section 11.4 on page
(Section 11.5 on page
DESCRIPTION
Network Address Translation (NAT) allows the translation of an Internet
protocol address used within one network (for example a private IP
address used in a local network) to a different IP address known within
another network (for example a public IP address used on the Internet).
Select the check box to enable NAT.
164) screen to enable NAT and
165) to forward incoming
169) to change your NBG-
NBG-460N User's Guide