Advanced Lan Screen - ZyXEL Communications NBG-4600N User Manual

Chapter 9 LAN
The following table describes the labels in this screen.
Table 53 Network > LAN > IP Alias
LABEL
IP Alias 1,2
IP Address
IP Subnet Mask
Apply
Reset

9.6 Advanced LAN Screen

To change your NBG-460N's advanced IP settings, click Network > LAN >
Advanced. The screen appears as shown.
Figure 107 Network > LAN > Advanced
The following table describes the labels in this screen.
Table 54 Network > LAN > Advanced
LABEL
Multicast Setup
Multicast
Any IP Setup
152
DESCRIPTION
Select the check box to configure another LAN network for the NBG-
460N.
Enter the IP address of your NBG-460N in dotted decimal notation.
Your NBG-460N will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the NBG-460N.
Click Apply to save your changes back to the NBG-460N.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
Select IGMP V-1 or IGMP V-2 or None. IGMP (Internet Group
Multicast Protocol) is a network-layer protocol used to establish
membership in a Multicast group - it is not used to carry user data.
IGMP version 2 (RFC 2236) is an improvement over version 1 (RFC
1112) but IGMP version 1 is still in wide use. If you would like to
read more detailed information about interoperability between IGMP
version 2 and version 1, please see sections 4 and 5 of RFC 2236.
NBG-460N User's Guide