ZyXEL Communications NBG-4600N User Manual page 307

The default password is 1234.
1
If this does not work, you have to reset the device to its factory defaults. See
2
Section 26.4 on page
I cannot see or access the Login screen in the Web Configurator.
Make sure you are using the correct IP address.
1
• The default IP address is 192.168.1.1.
• If you changed the IP address
address.
• If you changed the IP address and have forgotten it, see the troubleshooting
suggestions for
Check the hardware connections, and make sure the LEDs are behaving as
2
expected. See the Quick Start Guide.
Make sure your Internet browser does not block pop-up windows and has
3
JavaScripts and Java enabled. See
Make sure your computer is in the same subnet as the NBG-460N. (If you know
4
that there are routers between your computer and the NBG-460N, skip this step.)
• If there is a DHCP server on your network, make sure your computer is using
a dynamic IP address. See
• If there is no DHCP server on your network, make sure your computer's IP
address is in the same subnet as the NBG-460N. See
102.
Reset the device to its factory defaults, and try to access the NBG-460N with the
5
default IP address. See
If the problem continues, contact the network administrator or vendor, or try one
6
of the advanced suggestions.
Advanced Suggestions
• Try to access the NBG-460N using another service, such as Telnet. If you can
access the NBG-460N, check the remote management settings and firewall rules
to find out why the NBG-460N does not respond to HTTP.
• If your computer is connected to the WAN port or is connected wirelessly, use a
computer that is connected to a LAN/ETHERNET port.
NBG-460N User's Guide
310.
(Section 7.3 on page
I don't know the IP address of my NBG-460N.
Appendix A on page
Section 7.3 on page
Section 7.3 on page
Chapter 26 Troubleshooting
102), use the new IP
321.
102.
Section 7.3 on page
102.
307