Table of Contents
Advertisement
Chapter 6 AP Mode
To set your NBG-460N to AP Mode, go to Maintenance > Sys OP Mode >
2
General and select Access Point.
Figure 68 Maintenance > Sys OP Mode > General
A pop-up appears providing information on this mode. Click OK in the pop-up
3
message window. (See
pop-up.) Click Apply. Your NBG-460N is now in AP Mode.
Note: You do not have to log in again or restart your device when you change modes.
6.3 The Status Screen
Click on Status. The screen below shows the status screen in AP Mode.
Figure 69 Status: AP Mode
88
Section 24.4 on page 301
for more information on the
NBG-460N User's Guide
Advertisement
Table of Contents
Troubleshooting
