Wps Station Screen; Scheduling Screen - ZyXEL Communications NBG-418N v2 User Manual

Table 23 Network > Wireless LAN > WPS (continued)
LABEL
Apply
Refresh

6.8 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this screen, click
Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Figure 49 Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Table 24 Network > Wireless LAN > WPS Station
LABEL
Push Button
Or input station's
PIN number

6.9 Scheduling Screen

Use this screen to set the times your wireless LAN is turned on and off. Wireless LAN scheduling is
disabled by default. The wireless LAN can be scheduled to turn on or off on certain days and at
certain times. To open this screen, click Network > Wireless LAN > Scheduling tab.
Chapter 6 Wireless LAN
DESCRIPTION
Click Apply to save your changes back to the NBG-418N v2.
Click Refresh to get this screen information afresh.
DESCRIPTION
Use this button when you use the PBC (Push Button Configuration) method to configure
wireless stations's wireless settings. See
Click this to start WPS-aware wireless station scanning and the wireless security
information synchronization.
Use this button when you use the PIN Configuration method to configure wireless station's
wireless settings. See Section 5.3.2 on page
Type the same PIN number generated in the wireless station's utility. Then click Start to
associate to each other and perform the wireless security information synchronization.
NBG-418N v2 User's Guide
Section 5.3.1 on page
46.
71
45.