Sony XDS-1000 Operation Manual page 93

3
Set the IP address.
To select a different digit to be changed
Use the B and b buttons.
To change the value of a digit
Turn the PUSH SET knob.
Turning clockwise increases the value, and turning
counterclockwise decreases the value.
The V and v buttons can also be used.
To return to the factory default setting
Press the RESET button.
4
When all digits are set, press the SAVE function
button (F5).
This returns to the NETWORK menu.
5
Repeat steps 1 to 4 as required, to set the subnet mask
and default gateway.
6
In the NETWORK menu, press the SAVE function
button (F5).
7
When the message "NETWORK CONFIG WAS
CHANGED. PLEASE REPOWER." appears, power
the unit off and then on again with the on/standby
button.
To set the communications speed and
protocol
Set the communications speed and protocol (LINK
SPEED) to match the network environment.
To set the communications speed and protocol, proceed as
explained in the previous section "To display the
maintenance menu" to display the NETWORK menu and
then proceed as follows.
Contact your network administrator if you have any
questions about the proper settings for these items.
1
Select maintenance menu item M5: NETWORK
>M54: LINK SPEED.
2
Press the PUSH SET knob.
Combinations of the communications speed and
protocol (1Gbps FullDuplex, 100Mbps FullDuplex,
100Mbps HalfDuplex, 10Mbps FullDuplex, 10Mbps
HalfDuplex) appear, and the arrow flashes.
3
Press the PUSH SET knob or use the V or v button to
select a combination of communications speed and
protocol.
To return to the factory default setting
Press the RESET button.
4
Press the SAVE function button (F5).
This returns to the NETWORK menu.
5
In the NETWORK menu, press the SAVE function
button (F5).
6
When the message "NETWORK CONFIG WAS
CHANGED. PLEASE REPOWER." appears, power
the unit off and then on again with the on/standby
button.
93
Maintenance Menu