Sony XDS-1000 Operation Manual page 80

Item number Item name
723 INPUT VIDEO BLANKING
Sub-item
1 ALL LINE
2 LINE12-
| LINE20
10
2 LINE9-
| LINE22
15
726 H BLANKING WIDTH
728 OUTPUT SCH PHASE
731 WIDE MODE
Sub-item
1 INPUT
2 OUTPUT
740 MASTER LEVEL (HD)
741 Y LEVEL (HD)
742 PB LEVEL (HD)
80
Setup Menu
Menu items in the 700s, relating to video control
Settings
Switch blanking on or off for lines in the vertical blanking interval of input
video signals. Lines can be specified individually. Y/C signals and odd/
even fields are blanked simultaneously.
Blanking in recorded signals is carried out according to these settings.
---: Specify the blanking for each line separately
blank [blnk]: Regardless of the settings of other sub-items, blank all
lines which can be specified in this menu item.
throu [thru]: Regardless of the settings of other sub-items, switch
blanking off for all lines which can be specified in this menu item.
In 59.94i/59.94P/ Specify blanking for lines 12 to 20.
29.97P mode blank [blnk]: Switch blanking on.
throu [thru]: Switch blanking off.
In 50i/50P/25P Specify blanking for lines 9 to 22.
mode blank [blnk]: Switch blanking on.
throu [thru]: Switch blanking off.
a)
Select the horizontal blanking width of the output analog video signal.
narrow [narow]: Digital blanking (narrow)
wide: Analog blanking (wide)
When "wide" is selected, the horizontal blanking width complies with
SMPTE-170M, and normally the blanking is widened and the image
becomes narrower. It is recommended to select "narrow" at the editing
stage, then later, for broadcast transmission to select "wide", to output a
signal conforming to the standard. Note, however, that "narrow" has to
be always selected for SDI signals.
a)
Set the subcarrier H phase.
–512 to 0 to 511
a)
Specify whether to record and play back with the addition of wide picture
information.
Select whether to save wide picture information when recording.
auto: Automatically save wide picture information when it is detected in
the selected input video signal.
on: Always save wide picture information.
off: Never save wide picture information
Select whether to add wide picture information to the signal output when
down-converter output is set to squeeze mode.
through [thru]: Do not add.
auto: Add.
Notes
• To add wide picture information to the output signal, another setting is
required in addition to this item. In setup menu item 703, set line 16
(59.94i/59.94P/29.97P mode (J)), line 20 (59.94i/59.94P/29.97P mode
(UC)), or line 23 (50i/25P mode) to "throu".
• In 59.94i/59.94P/29.97P mode (J), output of wide picture information is
given priority if the VITC insertion line is set to line 16 in setup menu
item 601 or 602.
• In 59.94i/59.94P/29.97P mode (UC), output of wide picture information
is given priority if the VITC insertion line is set to line 20 in setup menu
item 601 or 602.
Adjust the high-definition video signal output from the HD-SDI OUTPUT
or HDMI OUTPUT connectors. This adjusts the Y, PB, and PR levels
simultaneously.
–2048 to 0 to 846
Adjust the Y level of the high-definition video signal output from the
HD-SDI OUTPUT or HDMI OUTPUT connectors.
–2048 to 0 to 846
Adjust the PB level of the high-definition video signal output from the
HD-SDI OUTPUT or HDMI OUTPUT connectors.
–2048 to 0 to 846