Playback - Sony XDS-1000 Operation Manual

Note that no recorded clip contents are lost when the
on/standby button on the front panel is set to standby
during recording, because the unit does not enter standby
mode until after the end of recording processing.
To adjust the audio recording levels
When carrying out audio recording at a reference
level
Set the VARIABLE switch to "PRESET".
The audio signals will be recorded at a preset reference
level.
You can change the reference level and the input levels
with maintenance menu item M37: AUDIO CONFIG.
See page 91 for more information about how to make
maintenance menu settings.
Manually adjusting the audio recording levels
Set the VARIABLE switch to "REC" and use the CH-1/
ALL CH and CH-2 to CH-4 knobs to adjust CH-1 to CH-
4, and use A5 VOL to A8 VOL on page P3 AUDIO of the
function menu to adjust CH-5 to CH-8 so that the audio
level indications on the audio level meters do not exceed 0
dB for a maximum volume.
48

Playback

Playback
This section describes playback of video and audio on the
unit.
Before starting playback, make the following settings and
adjustments.
Selection of time data to display: Select with CNTR SEL
on HOME page of the function menu.
Selection of audio channels to monitor: Select with
MONITR L and MONITR R on the HOME page of
the function menu.
Volume adjustment of the monitor audio: Adjust with
the LEVEL adjustment knob.
Playback target
Only the currently selected clip/EDL on the internal
storage is played back.
The available playback types include normal playback,
high-speed playback in the forward or reverse directions,
and jog, shuttle, and variable-speed playback. Playback
stops when it reaches the start or end of the clip/EDL. The
next and preceding clips are not played, even if they exist
on the media.
To move to another clip, press the PREV, NEXT, SHIFT
+ PREV, or SHIFT + NEXT button, or perform a
thumbnail search.
About the playback start position
Immediately after this unit starts
All clips are closed. To play a clip or an EDL, select it in a
clip list screen.
After recording
The unit stops at the position where recording ended.
To play back a clip, press the PREV button to move to the
start frame of any clip or press the PREV button with the
PLAY button held down to move to any position.
After playback stops
When you press the STOP button, playback stops at that
position and the position is saved.
When you press the PLAY button, playback starts from the
stopped position.
Note
When playback is stopped on an EDL, the playback
position is not saved.
1080/720 cross convert function
You can output 720 while playing clips recorded as 1080,
and output 1080 while playing clips recorded as 720.