Sony XDS-1000 Operation Manual page 50

Note
The PREV and NEXT buttons cannot be used to move
from the currently selected clip to an EDL or move from
the currently selected EDL to a clip or to another EDL.
To stop playback
Press the STOP button.
Playback in jog mode
In jog mode, you can control the speed of playback by the
speed of turning the shuttle/jog dial. The playback speed
range is –1 to +1 times normal speed.
To carry out playback in jog mode, select a clip or an EDL
(see page 49), and then proceed as follows.
JOG indicator: Lit
1
Press the shuttle/jog dial to light the JOG indicator.
The shuttle/jog dial enters jog mode.
2
Press the SHTL/JOG button or VAR/JOG button,
turning it on.
3
Turn the shuttle/jog dial in the desired direction, at the
speed corresponding to the desired playback speed.
Playback in jog mode starts.
4
To stop playback in jog mode, stop turning the shuttle/
jog dial.
When setup menu item 101 SELECTION FOR
SEARCH DIAL ENABLE is set to "dial" (factory
default setting), you can start jog playback by simply
rotating the shuttle/jog dial, even when the SHTL/JOG
and VAR/JOG buttons are not lit.
Playback in shuttle mode
In shuttle mode, you can control the speed of playback by
the angular position of the shuttle/jog dial. The range of
playback speed is ±20 times normal speed.
To carry out playback in shuttle mode, select a clip or an
EDL (see page 49), and then proceed as follows.
50
Playback
1
Press the shuttle/jog dial to turn off the JOG indicator.
The shuttle/jog dial enters shuttle mode.
2
Press the SHTL/JOG button, turning it on.
3
Turn the shuttle/jog dial to the desired angle
corresponding to the desired playback speed.
Playback in shuttle mode starts.
4
To stop playback in shuttle mode, return the shuttle/
jog dial to the center position, or press the STOP
button.
When setup menu item 101 SELECTION FOR
SEARCH DIAL ENABLE is set to "dial" (factory
default setting), you can start shuttle playback by
simply rotating the shuttle/jog dial, even when the
SHTL/JOG button is not lit.
Note
Video and audio become discontinuous if you conduct
shuttle playback of a clip that does not have proxy AV
data.
To alternate between normal-speed playback and
shuttle mode playback
Set the shuttle/jog dial to the position corresponding to the
desired shuttle playback speed, then switch between
normal-speed playback and shuttle playback by pressing
the PLAY and SHTL/JOG buttons alternately.
Playback in variable-speed mode
In variable-speed mode, you can control the speed of
playback in the range of –2 to +2 times normal speed.
To carry out playback in variable-speed mode, select a clip
or an EDL (see page 49), and then proceed as follows.
JOG indicator: Unlit