Caution – When performing the following steps, use special care to enter the correct
numbers. Once the power distribution board has been programmed with a chassis
serial number or server part number, the number cannot be changed.
sc> setsc sc_servicemode true
Warning: misuse of this mode may invalidate your warranty.
sc> setcsn -c chassis_serial_number
Are you sure you want to permanently set the Chassis Serial Number
to chassis_serial_number [y/n]? y
setcsn: Chassis serial number recorded.
sc> setcpn -p chassis_part_number
Are you sure you want to permanently set the Chassis Part Number
to chassis_part_number [y/n]? y
setcpn: Chassis part number recorded.
sc> showplatform
SPARC-Enterprise-T5140
Chassis Serial Number: chassis-serial-number
Domain Status
------ ------
SO Running
sc> setsc sc_servicemode false
Related Information
"Remove the Power Distribution Board" on page 164
■
Servicing Power Supply Backplanes
(SPARC Enterprise T5240 Servers)
The following topics explain how to remove and install power supply backplanes in
SPARC Enterprise T5240 servers. Power supply backplanes are not used in SPARC
Enterprise T5140 servers.
"Power Supply Backplane Overview" on page 171
■
Related Information
."Servicing Power Distribution Boards" on page 163
■
170
SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009