Fujitsu SPARC ENTERPRISE T5140 Service Manual page 116

Note – Depending on the configuration of ILOM POST variables and whether POST
detected faults or not, the system might boot, or the system might remain at the ok
prompt. If the system is at the ok prompt, type boot.
d. Return the virtual keyswitch to Normal mode.
-> set /SYS keyswitch_state=Normal
Set 'ketswitch_state' to 'Normal'
e. Switch to the system console and type the Solaris OS fmadm faulty
# fmadm faulty
5. Switch to the ILOM command shell.
6. Run the show faulty command.
-> show faulty
Target
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0
/SP/faultmgmt/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
If the show faulty command reports a fault with a UUID go on to
show faulty does not report a fault with a UUID, you are done with the
verification process.
90 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
command.
No memory faults should be displayed.
If faults are reported, refer to the diagnostics instructions described in
Troubleshooting Overview" on page 23
fault.
| Property
| fru
| timestamp
| sunw-msg-id
|
| uuid
|
| timestamp
|
for guidance in troubleshooting the
| Value
| /SYS/MB/CMP0/BR0/CH1/D0
| Dec 14 22:43:59
| SUN4V-8000-DX
|
| 3aa7c854-9667-e176-efe5-e487e520
| 7a8a
| Dec 14 22:43:59
|
"ILOM
Step 7. If