Install The Power Distribution Board - Fujitsu SPARC ENTERPRISE T5140 Service Manual

▼ Install the Power Distribution Board

1. Lower the power distribution board/bus bar assembly into the chassis.
The power distribution board fits over a series of mushroom standoffs in the floor
of the chassis.
2. Slide the power distribution board/bus bar assembly to the right, until it plugs
into the paddle card.
Installing a Power Distribution Board in a SPARC Enterprise T5140 Server
FIGURE:
3. Install the No. 2 Phillips screw to secure the power distribution board to the
chassis.
4. (SPARC Enterprise T5240 server) Attach the four No. 2 Phillips screws securing
the power distribution board to the power supply backplane.
Servicing Boards and Components 167