Display System Components - Fujitsu SPARC ENTERPRISE T5140 Service Manual

The database that contains the list of disabled components is referred to as the ASR
blacklist (asr-db).
In most cases, POST automatically disables a faulty component. After the cause of
the fault is repaired (FRU replacement, loose connector reseated, and so on), you
might need to remove the component from the ASR blacklist.
The following ASR commands enable you to view and add or remove components
(asrkeys) from the ASR blacklist. You run these commands from the ILOM ->
prompt.
Command
show components
set asrkey component_state=Enabled
set asrkey component_state=Disabled
Note – The asrkeys vary from system to system, depending on how many cores
and memory are present. Use the show components command to see the asrkeys
on a given system.
After you enable or disable a component, you must reset (or power cycle) the system
for the component's change of state to take effect.
Related Information
"Display System Components" on page 51
■
"Disable System Components" on page 52
■
"Enable System Components" on page 53
■

▼ Display System Components

The show components command displays the system components (asrkeys) and
reports their status.
50 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
Description
Displays system components and their
current state.
Removes a component from the asr-db
blacklist, where asrkey is the component to
enable.
Adds a component to the asr-db blacklist,
where asrkey is the component to disable.