Fujitsu SPARC ENTERPRISE T5140 Service Manual page 62

Note – The value of keyswitch_state must be normal when individual POST
parameters are changed.
TABLE:
Parameter
keyswitch_state normal
diag_mode
diag_level
diag_trigger
diag_verbosity
The following flowchart is a graphic illustration of the same set of ILOM set
command variables.
36 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
ILOM Properties Used to Manage POST Operations
Values
diag
stby
locked
off
normal
service
max
min
none
user_reset
power_on_reset
error_reset
all_resets
none
min
normal
max
Description
The system can power on and run POST (based
on the other parameter settings). This parameter
overrides all other commands.
The system runs POST based on predetermined
settings.
The system cannot power on.
The system can power on and run POST, but no
flash updates can be made.
POST does not run.
Runs POST according to diag_level value.
Runs POST with preset values for diag_level
and diag_verbosity.
If diag_mode = normal, runs all the minimum
tests plus extensive processor and memory tests.
If diag_mode = normal, runs minimum set of
tests.
Does not run POST on reset.
Runs POST upon user initiated resets.
Only runs POST for the first power on. This
option is the default.
Runs POST if fatal errors are detected.
Runs POST after any reset.
No POST output is displayed.
POST output displays functional tests with a
banner and pinwheel.
POST output displays all test and informational
messages.
POST displays all test, informational, and some
debugging messages.